Electronic Range Control (Erc) - GE Café CS980SN1SS Technical Service Manual

6. Remove the two 1/4-in. hex-head screws and
the heat shield from the range.
Heat Shield
Note: When installing
rangetop, be sure to
engage slots in rangetop
underneath locator pins.
7. Disconnect the 2 rangetop wire harnesses.
8. Remove the 1/4-in. hex-head screw that
attaches the ground wire to the range.
Disconnect
9. Carefully lift the rangetop and place it on a
protective surface.
Note: When installing the rangetop, be sure both
rangetop wire harnesses are positioned underneath
the heat shield.
Control Panel
To access the control panel:
1. Remove the rangetop. (
2. Remove the 4 Phillips-head screws from the
bottom of the control panel.
Locator Pin
Disconnect
.)
See Rangetop
3. Remove the 2 Phillips-head locator pins from the
top of the range.
4. Place a towel or protective item across the top
of each side panel.
5. Slide the control panel forward, rotate and place
the panel top down across the range on the
protective surfaces as shown.
Service Position

Electronic Range Control (ERC)

The ERC is attached to a bracket that houses the
touch panel. It is necessary to remove the bracket
from the control panel to access the screws that
attach the ERC. Viewed in the service position, the
bracket is attached with 2 Phillips-head screws at
the top and 2 tabs at the bottom that lock into a fold
in the control panel.
To remove the electronic oven control (ERC):
1. Place the control panel in the service position.
(See
Control Panel
2. Mark and disconnect all wiring from the ERC.
3. Remove the 2 Phillip-head screws from the top
of the control panel.
– 13 –
.)
(Continued next page)