Roland M-UF2G User Manual

logo_e.eps
USB FLASH MEMORY
M-UF2G
201a
Before using the product, carefully read the sections
entitled: "USING THE UNIT SAFELY" and "IMPORTANT
NOTES." These sections provide important information
concerning the proper operation of the product.
Additionally, in order to feel assured that you have gained
a good grasp of every feature provided by your new
product, Owner's Manual should be read in its entirety. The
manual should be saved and kept on hand as a convenient
reference.

Main Specifications

Interface USB 2.0/1.1
Connector USB series A
Capacity 2 GB
Roland products that support USB memory/
Compatible Computers that have a USB interface and are
Devices running one of the following operating
systems
Operating Windows XP, Windows Vista
System Mac OS X V10.4.3 or later
962a
* In the interest of product improvement, the specifications
and/or appearance of this product are subject to change
without prior notice.
* The ReadyBoost feature of Windows Vista is not supported.
For EU Countries
Copyright © 2009 ROLAND CORPORATION
All rights reserved. No part of this publication may be reproduced in any form
without the written permission of ROLAND CORPORATION.
The M-UF2G is flash memory that uses a USB interface.
You can connect it to products that use of USB
memory, such as Roland products. Before use, be sure
to read the owner's manual of your product as well.
931kai
* When connecting the product to another device, carefully in-
sert it all the way in until it is firmly in place, taking care that
it is oriented and inserted in the correct direction. Do not use
excessive force when inserting it.
The included tube is for preventing accidental loss of
the cap. Operation will not be affected if you remove
this tube.
Cap
Tube
When files are being read from, or written to the
M-UF2G, the LED at the rear of the M-UF2G will blink.
* When not using the M-UF2G, attach the cap to cover the con-
nector for safety.
* Before disconnecting the M-UF2G from your device, follow
the instructions in the owner's manual of your device to en-
sure that the memory can be disconnected safely.
About WARNING and CAUTION Notices
Used for instructions intended to alert the user
to the risk of death or severe injury should the
unit be used improperly.
Used for instructions intended to alert the user
to the risk of injury or material damage should
the unit be used improperly.
* Material damage refers to damage or other
adverse effects caused with respect to the
home and all its furnishings, as well to
domestic animals or pets.
ALWAYS OBSERVE THE FOLLOWING
002a 004
• Do not open or perform any • Never use or store the
internal modifications on the product in places that are:
product.
• Subject to temperature
................................................................................
extremes (e.g., direct
011
sunlight in an enclosed
• Do not allow any objects (e.g.,
vehicle, near a heating
flammable material, coins,
pins); or liquids of any kind duct, on top of heat-generating
(water, soft drinks, etc.) to
equipment); or are
penetrate the product.
• Damp (e.g., baths, washrooms, on
wet floors); or are
................................................................................
• Exposed to steam or smoke; or are
013
• Subject to salt exposure; or are
• In households with small
children, an adult should
• Humid; or are
provide supervision until the
• Exposed to rain; or are
child is capable of following
• Dusty or sandy; or are
all the rules essential for the
• Subject to high levels of vibration
safe operation of the product.
................................................................................ and shakiness.
...............................................................................
IMPORTANT NOTES
Additional Precautions
551Kai
• Please be aware that the contents of
Placement
memory can be irretrievably lost as a
354a result of a malfunction, or the
• Do not expose the product to direct
improper operation of the product.
sunlight, place it near devices that
Unfortunately, it may be impossible
radiate heat, leave it inside an
to restore the contents of data that
enclosed vehicle, or otherwise subject
was stored in the product's memory
it to temperature extremes. Excessive
once it has been lost. Roland
heat can deform or discolor the
Corporation assumes no liability
product.
concerning such loss of data.
355b
553Kai
• When moved from one location to
• Use a reasonable amount of care
another where the temperature and/
when using the product's connector
or humidity is very different, water
and cap. Rough handling can lead to
droplets (condensation) may form
malfunctions.
inside the product. Damage or
malfunction may result if you attempt
Using This Product
to use the product in this condition.
705Kai
Therefore, before using the product,
• Never touch the connector of this
you must allow it to stand for several
product. Also, avoid getting the
hours, until the condensation has
terminals dirty.
completely evaporated.
708Kai
• This product is constructed using
precision components; handle the
cards carefully, paying particular note
to the following.
About the Symbols
The symbol alerts the user to important instructions or warnings.
The specific meaning of the symbol is determined by the design
contained within the triangle. In the case of the symbol at left, it is used
for general cautions, warnings, or alerts to danger.
The symbol alerts the user to items that must never be carried out
(are forbidden). The specific thing that must not be done is indicated by
the design contained within the circle. In the case of the symbol at left, it
means that the unit must never be disassembled.
The symbol alerts the user to things that must be carried out. The
specific thing that must be done is indicated by the design contained
within the circle. In the case of the symbol at left, it means that the
power-cord plug must be unplugged from the outlet.
014
• Protect the product from
strong impact.
(Do not drop it!)
106
• Never step on, nor place
heavy objects on the product.
...............................................................................
118aKai
• This product, the cap
removed from it, and the tube
included to prevent loss of
the cap must be kept in a safe place
out of children's reach, so that there is
no chance of them being swallowed
accidentally.
...............................................................................
• To prevent damage to the cards
from static electricity, be sure to
discharge any static electricity from
your own body before handling the
cards.
• Do not touch or allow metal to
come into contact with the contact
portion of the cards.
• Do not bend, drop, or subject cards
to strong shock or vibration.
• Do not keep cards in direct
sunlight, in closed vehicles, or
other such locations (storage
temperature: -40 to 85˚C).
• Do not allow cards to become wet.
• Do not disassemble or modify the
cards.
204
* Microsoft and Windows are registered
trademarks of Microsoft Corporation.
206j
* Windows® is known officially as:
"Microsoft® Windows® operating
system."
207+209
* Mac OS, Apple and Macintosh are
registered trademarks of Apple Inc.