System Setup (Beep, Power Save, Etc.) - Canon ZR 900 Instruction Manual

Additional Information
[MARKERS]: You can display a grid or a horizontal line at the center of the screen. Use the
markers as a reference to make sure your subject is framed correctly (vertically and/or
horizontally).
• Using the markers will not affect the recordings on the tape.
[DISPLAYS]: You can hide the on-screen displays to show only the playback picture on the
full screen.
• Tape operation displays appear for 2 seconds.
• Warning messages and the data code (if activated) will appear, even when set to
[mJ
OFF<PLAYBK>].
• All on-screen displays will appear while the playback image is magnified or a digital
effect is activated.
[6SEC.DATE]: When you start playing back a tape or when the date of the recording
changes, the date and time will be displayed for 6 seconds.
[DEMO MODE]: The demonstration mode displays the camcorder's main features. It starts
automatically when the camcorder is powered with the power adapter if you leave it turned
on without loading a recording media for more than 5 minutes.
• To cancel the demo mode once it started, press any button, turn off the camcorder or
insert a videocassette.
,<1P
SYSTEM SETUP
•
•
•
[lmi ON], [mJ OFF
((I(1[l]
['iii») HIGH VOLUME],
[ 'iii>
LOW VOLUME],
[mJ
OFF]
[lmi
ON],
[mJ
OFF]
............................
[POWER SAVE]
N4:n~
[WL.REMOTE]
[BEEP]
~~tiI·)
[WL. REMOTE]: Allows the camcorder to be operated with the wireless controller.
[BEEP]: A beep will accompany some operations like turning on the camcorder, the self-
timer countdown, etc. It also serves as a warning beep under unusual conditions.
[POWER SAVE]:
In order to save power when the camcorder is powered by a battery
pack, it will automatically shut off if left without any operation for 5 minutes. Approximately
30 seconds before the camcorder shuts off, the message" &AUTO POWER OFF" will
appear.
60