Tq-3 Radio System Rules - Traxxas T-Maxx 4910 Owner's Manual

Remember, always turn the
TQ-3 transmitter on first and
off last to avoid damage to
your T-Maxx. Never turn the
radio off while the engine is
running.
14 • T-MAXX
THE TRAXXAS TQ-3 RADIO SYSTEM

TQ-3 RADIO SYSTEM RULES

Each time you prepare to run your T-Maxx,
you must clear your frequency to be sure no
one else in the area is using the same channel
as you.
There are six possible channels, numbered
1 through 6. Each is represented by a color.
Look at the crystal plugged into the back of
your transmitter to determine which channel
your truck is assigned to.
Always turn your TQ-3 transmitter on first and off last. This procedure
will help to prevent your T-Maxx from receiving stray signals from
another transmitter, or other source, and running out of control.
1
Always turn your transmitter on first.
Always have the transmitter and receiver turned on before you
Channel 1 start the engine. Never turn the radio system off while the engine is
Brown
running. The on/off switch in the model only turns the receiver on
Channel 2
and off. It does not turn off the engine.
Red
Channel 3
Always use new or freshly charged batteries for the transmitter, and
Orange
make sure the receiver batteries are fresh. Weak batteries will limit
Channel 4
the radio signal between the receiver and the transmitter. Loss of the
Yellow
radio signal can cause you to lose control of your T-Maxx.
Channel 5
Green
Channel 6
Blue
2
Always turn your receiver on second.
3
Then start your engine.