Hotpoint 18 Owner's Manual And Installation Instructions page 13

Installation
Instructions
If you have questions, call 800.GE.CARES (800.432.2737)
BEFORE YOU BEGIN
Read these instructions completely and carefully.
IMPORTANT –
•
instructions for local inspector's use.
IMPORTANT –
•
governing codes and ordinances.
Note to Installer –
•
instructions with the Consumer.
Note to Consumer –
•
for future reference.
• Skill level – Installation of this appliance requires
basic mechanical skills.
• Completion time – Refrigerator Installation
15 minutes.
• Proper installation is the responsibility of the
installer.
• Product failure due to improper installation is not
covered under the Warranty.
WATER SUPPLY TO THE ICEMAKER
(ON SOME MODELS)
If the refrigerator has an icemaker, it will have to be
connected to a cold water line. A GE water supply kit
(containing tubing, shutoff valve, fittings and
instructions) is available at extra cost from your dealer
or by visiting our Website at GEAppliances.com or
Parts and Accessories, 800.626.2002.
REFRIGERATOR LOCATION
• Do not install the refrigerator where the temperature
will go below 60°F (16°C) because it will not run often
enough to maintain proper temperatures.
• Do not install the refrigerator where the temperature
will go above 100°F (37°C) because it will not perform
properly.
• Install it on a floor strong enough to support it fully
loaded.
Save these
Observe all
Be sure to leave these
Keep these instructions
or visit our Website at:
CLEARANCES
Allow the following clearances for ease of installation,
proper air circulation and plumbing and electrical
connections.
• Sides 1/8" (3 mm)
• Top 1" (25 mm)
• Back 1" (25 mm)
If the refrigerator is to be installed next to a wall on the
hinge side, allow 5/16" (8 mm) door clearance.
ROLLERS
(ON SOME MODELS)
The rollers have 3 purposes:
• Rollers adjust so the door closes easily when opened
about 45°.
• Rollers adjust so the refrigerator is firmly positioned on
the floor and does not wobble.
• Rollers allow you to move the refrigerator away from the
wall for cleaning.
NOTE: When rollers are properly adjusted, the top
of the refrigerator will not be level but will have a slight
backward tilt.
To adjust the rollers, remove
the base grille by grasping it
about 6" from each end and
pulling its bottom edge
toward you.
Turn the two front roller
adjusting screws clockwise
to raise the front of the
refrigerator, counterclockwise
to lower it.
Replace the base grille by
inserting the tops of the
metal clips into the oval
vents, making sure one of
the plastic tabs on the back
of the grille goes into each of
the oval vents. Then push the bottom
of the grille forward until it snaps into place.
13
Refrigerator
Models 18 and 19
www.Hotpoint.com