Traxxas Stampede 4x4 67054 Owner's Manual page 25

MAINTAINING YOUR MODEL
Suspension and slipper clutch assembly removal
Your model was designed with ease of disassembly in mind. The entire front and rear suspension
assemblies can be removed from the chassis fully intact with the removal of only a few screws.
Refer to the exploded views included in the your model's Service Support Guide for complete
assembly diagrams.
• Removing the front suspension module
1. Remove the two 4x12 button-head cap screws from the front of the chassis.
2. Remove the two 4x10 button-head cap screws from the top of the chassis.
3. Remove the 3x15 button-head cap screw from the steering link under the chassis.
4. Pull the front suspension assembly away from the chassis.
5. The driveshaft will come out with the front module. Remove screw pin to remove driveshaft.
Rear Suspension
• Removing the rear suspension module (Slipper clutch assembly removal)
Assembly
1. Remove the two 4x12 button-head cap screws from the top of the chassis.
2. Remove the two 4x12 button-head cap screws from the bottom of the chassis.
3. Pull the rear suspension assembly away from the chassis.
4x12BCS
4. The slipper clutch assembly can now be removed.
Slipper Clutch
4x10CCS
Assembly
4x12BCS
4x12BCS
Front Suspension
Assembly
3x15BCS
STAMPEDE 4X4 • 25