Power Supply - NexxTech 1219515 Instruction Manual

CONTROLS
Top and front panels (See [1])
(1) DISPLAY
- shows the clock and CD function.
(2) DISPLAY BUTTON
- shows the CD playback track number.
(3) SLEEP
- adjusts timer options for CD/radio.
(4) POWER
- switches power on/off.
(5) ALARM SELECTOR
- selects AL-1 / AL-2 / AL1+AL2 / OFF or SET.
(6) ALARM1
- toggle to set /show the times for the alarm1.
(7) ALARM2
- toggle to set /show the times for the alarm2.
(8) CLOCK
- toggle to set the times for the clock time.
(9) SNOOZE
- switches off alarm for 5 minute period.
(10) PROGRAM
CD : - programs and reviews programmed
track numbers.
(11) SKIP- / MINUTE , SKIP+ / HOUR
- adjusts clock minute / alarm minute times.
- skip CD tracks / searches for a particular
passage.
(12) STOP
- stops CD playback; erases a CD program.
(13) PRESS TO PLAY
- starts or pauses CD play.
(14) CD DOOR
- lift here to open / close the CD door.
(15) FUNCTION SELECTOR (CD AM FM
BUZZER)
- selects source of sound (CD / AM / FM /
BUZZER).
(16) STEREO HEADPHONE JACK
- 3.5mm stereo headphone jack.
(17) VOLUME
- adjusts volume level.
(18) DIAL WINDOW
- shows the AM /FM dial frequency.
(19) REPEAT
- repeats a track / CD / program.
(20) TUNING CONTROL
- selects AM / FM station.
(21) FM PIG TAIL ANTENNA
- to improve FM reception.
(22) BATTERY DOOR
- to open battery compartment.
121-9021manual.indd 5
1. Connect the AC plug to the wall outlet.
2. To disconnect the set completely from the
MEMORY BACKUP
Open the battery compartment and insert one
batteries, type 9V (6F22) "not included", the
battery terminals inside the Compartment. It
(AL-1 AL-2 AL1+AL2 OFF/SET)
can only be connected one way.
If the power is interrupted the clock display
goes off and the unit will not operate. However
the battery will maintain the time and alarm
setting, and when the power is stored the time
and alarm setting will be correct.
If the battery is exhausted, or there is no
battery installed and the power is interrupted,
the time and alarm setting will be lost. When
power is restored the clock display, you will
notice that the time on the display is incorrect,
check you alarm setting as well if they are
also incorrect this indicates that the power
was interrupted and the battery is exhausted.
Replace the battery with a new one and reset
both the time and alarm setting.
Using AC Power
1. Check if the power voltage, as shown on
2. Connect the power cord to the AC MAINS
3. To switch off completely, unplug the power
5 5

POWER SUPPLY

Power Supply
power supply, withdraw the AC plug from
the wall outlet.
the type plate located on the bottom of the
set, corresponds to your local AC power
supply. If it does not, consult your dealer or
service center.
inlet and the wall outlet. The power supply
is now connected and ready for use.
cord from the wall outlet.
• Unplug the power cord from the wall outlet to
protect your set during heavy thunderstorms.
3/17/04 3:13:06 PM