Assembly; Fitting The Loop Handle; Assembling And Dismantling The Two-Piece Shaft - McCulloch B28 PS Operator's Manual

NOTE:
Make sure unit is assembled
correctly as shown in this manual.

Fitting the loop handle

S Position the handle on the shaft. Note that
the handle must be mounted between the
two arrows on the shaft.
S Fit the screw, securing plate and wing nut
as shown in the diagram.
S Make a final adjustment of the J- -handle
to a comfortable working position.
Tighten the wing nut.
WARNING:
To avoid serious
injury, only use grass blades/grass
cutters or trimmer heads with plastic
blades when the J-handle is fitted.
Never use saw blades!
Assembling and dismantling
the two- -piece shaft

Assembly:

S Loosen the coupling by turning the knob.
S Position locking/release button (A) of
attachment into guide recess (B) of
coupling.
B
115432326 Rev. 4 2/17/12
ASSEMBLY
S Push the attachment into the coupling
until the locking/release button snaps
into the primary hole (C).
C
S Before using the unit, tighten the knob
securely.
WARNING:
designed to be used in the primary
hole unless otherwise stated in the
applicable attachment instruction
manual. Using the wrong hole could
lead to serious injury or damage to
the unit.
Dismantling:
S Loosen the coupling by turning the knob.
S Press and hold the locking/release button
(A).
S While securely holding the engine and
upper shaft, pull the attachment straight
out of the coupling.
A
All attachments are
A
English--- 10