Ground Balancing; Assembling The Detector; Headphone Jack; Using Headphones - Bounty Hunter Land Ranger PRO Owner's Manual

GROUND BALANCING

MANUAL GROUND ADJUSTMENT
GROUND
Refer to the section of the manual for instructions on how to manually
adjust the detector's internal Ground setting.
If the Ground setting is incorrect, there will be a difference in the sound as
the searchcoil is either moving toward or away from the ground. It sounds
like you are either pulling the sound out of the ground, or pushing the
sound into the ground.
• If the sound gets louder as you raise the searchcoil, increase the
Ground setting.
• If the sound gets louder as you lower the searchcoil, reduce the Ground
setting.
NOTE: Experienced users often prefer to adjust the Ground setting to
get a weak but audible response when lowering the searchcoil. This is
called "adjusting for positive response."

HEADPHONE JACK

Push the tab up and lock into place to
expose the headphone jack.
This detector has a 1/4" headphone jack.
It works with any stereo headphone that
has a 1/4" plug.
When the headphone jack is connected,
speaker volume is disabled.

USING HEADPHONES

Using a detector with headphones facilitates detection of the weakest signals
and also extends battery life.
It also allows you to hear subtle changes in the sound more clearly, particularly
if searching in a noisy location. For safety reasons, do not use headphones
near traffic or where other dangers are present. This device is to be used with
interconnecting cables/headphone cables shorter than three meters.
20

ASSEMBLING THE DETECTOR

G
1 Hold S-ROD upright.
G
2 Loosen LOCKING COLLAR on S-ROD;
rotate counterclockwise.
G
3 Insert LOWER STEM into S-ROD with the
SILVER BUTTON pointed upward.
G
4 Rotate the LOWER STEM until the
SILVER BUTTON locates and clicks into
a hole.
S-ROD
G
5 Attach the SEARCHCOIL to the LOWER
STEM using the BOLT and KNURLED
KNOB.
G
SWIVEL
6 Adjust the LOWER STEM to a length that
DOOR
lets you maintain a comfortable upright
posture while holding the detector relaxed
at your side with the SEARCHCOIL
parallel to the ground in front of you.
G
7 Wind the CABLE around the STEM.
Leave slack in the cable at the bottom to
allow the searchcoil to pivot.
G
8 Align the pins on the CABLE PLUG to the
connector holes on the rear of the control
housing.
G
9 Push in CABLE PLUG.
G
1 0 Twist the LOCKING COLLAR fully in the
clockwise direction until stems are locked
securely together.
LOCKING
COLLAR
INTERNAL
CAM LOCK
SILVER BUTTON
LOWER
STEM
S-ROD
LOWER STEM
5