Custom Ip Filters - D-Link Vonage VWR User Manual

Chapter  - Configuration

Custom IP Filters

Filter Name - Enter a name of your filter rule.
Enable - Check to enable the filter rule.
Source IP - Enter the LAN-side IP address.
Source Netmask - Enter the LAN-side subnet mask.
Destination IP - Enter the destination IP address (0.0.0.0 for all).
Destination Netmask - Enter the destination subnet mask (255.255.255.255 for all).
Port Start - Enter the starting port to block.
Port End - Enter the ending port to block.
Protocol - Select the protocol (TCP, UDP, TCP and UDP, ICMP, and ANY).
D-Link VWR User Manual