Using The Equalizer - Pioneer DEH-P65BT Operation Manual

Operating this unit

Using the equalizer

The equalizer lets you adjust the equalization
to match car interior acoustic characteristics
as desired.
Recalling equalizer curves
There are six stored equalizer curves which
you can easily recall at any time. Here is a list
of the equalizer curves:
Display Equalizer curve
POWERFUL Powerful
NATURAL
Natural
VOCAL Vocal
CUSTOM
Custom
FLAT Flat
SUPER BASS
Super bass
! CUSTOM is an adjusted equalizer curve
that you create.
! When FLAT is selected no supplement or
correction is made to the sound. This is
useful to check the effect of the equalizer
curves by switching alternatively between
FLAT and a set equalizer curve.
1 Use MULTI-CONTROL to select P.EQ.
2 Push MULTI-CONTROL left or right to
select the equalizer.
Each time MULTI-CONTROL is pushed left or
right, equalizer curves are selected in the fol-
lowing order:
POWERFUL—NATURAL—VOCAL—CUSTOM
—FLAT—SUPER BASS
Adjusting equalizer curves
You can adjust the currently selected equalizer
curve setting as desired. Adjusted equalizer
curve settings are memorized in CUSTOM.
1 Use MULTI-CONTROL to select EQ.
2 Push MULTI-CONTROL left or right to
select the equalizer band to adjust.
Each time MULTI-CONTROL is pushed left or
right, equalizer bands are selected in the fol-
lowing order:
LOW (low)—MID (mid)—HI (high)
3 Push MULTI-CONTROL up or down to
adjust the level of the equalizer band.
Each time MULTI-CONTROL is pushed up or
down, the level of the equalization band in-
creases or decreases.
+6 to –6 is displayed as the level is increased
or decreased.
# You can then select another band and adjust
the level.
Note
If you make adjustments, CUSTOM curve is up-
dated.
Fine-adjusting equalizer curve
You can adjust the center frequency and the Q
factor (curve characteristics) of each currently
selected curve band (LOW/MID/HI).
Level (dB)
Center frequency
1 Use MULTI-CONTROL to select fre-
quency and the Q factor display.
Frequency and the Q factor (e.g.,
EQ-LOW 80HZ Q1W) appears in the display.
2 Push MULTI-CONTROL left or right to
select the desired frequency.
Each time MULTI-CONTROL is pushed left or
right, frequencies are selected in the following
order:
Low: 40—80—100—160 (Hz)
Mid: 200—500—1k—2k (Hz)
High: 3.15k—8k—10k—12.5k (Hz)
Section
Q=2W
Q=2N
Frequency (Hz)
35
En
02