Transmitter And Receiver; Jato 3.3 Wiring Diagram - Traxxas Jato 3.3 5507 Owner's Manual

Your model is equipped with the TQi 2.4 GHz transmitter with Traxxas Link Model Memory. The transmitter has two channels for
controlling your throttle and steering. The receiver inside the model has 5 output channels. Your model is equipped with two
servos and a receiver.

TRANSMITTER AND RECEIVER

Set Button Throttle Neutral
Adjust
Red/Green Status LED
see page 40 for more info
Menu Button
Steering
Trim
Multi-Function
Knob
Throttle
Trigger
Link
Button
Power Switch Battery Compartment
Optional
Charge Jack
Steering Wheel
(for optional NiMH
battery pack)
On/Off
Switch
Antenna
Sensor Expansion
Port **
Receiver
LED
* Not used
** Accessory sensor port for
use with TQi Docking Base
(see Traxxas.com and included
materials for more information)
TRAXXAS TQ RADIO SYSTEM
i

JATO 3.3 WIRING DIAGRAM

4-Cell
Battery Holder
Channel 2
Throttle Servo
Channel 1
Steering Servo
V/T - Voltage/Temp Senor Port**
RPM - RPM Sensor Port**
BATT/
CH5 - Battery
CH4 - Channel 4*
CH3 - Channel 3*
CH2 - Throttle Servo
CH1 - Steering Servo
CH1 - Channel 1*
Jato has a provision for
a built-in charging jack
so you do not have to
remove the battery pack
from the model. The wire
for the charging jack is
supplied with the factory
harness, and is stored
inside the receiver box.
It is not installed in the
charging jack to prevent
inadvertently charging
alkaline batteries.
Never use the charging
jack with the 4-cell battery
holder. The charging jack is
for optional rechargeable
5-cell nickel metal hydride
(NiMH) batteries only. See
page 10 for more details.
JATO 3.3 • 9