Traxxas Summit 5607 Owner's Manual page 17

Thermal Shutdown Protection
The EVX-2 is equipped with thermal shutdown protection to guard
against overheating caused by excessive current flow. If the operating
temperature exceeds safe limits, the EVX-2 will automatically shut
down and the EVX-2 LED will flash red. The LED on the face of the EVX-
2 will continuously flash red, even if the throttle trigger is moved back
and forth. After the speed control cools down to a safe level,
the LED will continuously shine green. The EVX-2 will once again
function normally.
EVX-2 Profile Selection
The speed control is factory set to Profile #1. To change the profile,
follow the steps on described below. The speed control should be
connected to the receiver and battery, and the transmitter should be
adjusted as described previously. The profiles are selected by entering
the programming mode.
EVX-2 Profile Description
Profile #1 (Sport Mode): 100% Forward, 100% Brakes, 100% Reverse
Profile #2 (Race Mode): 100% Forward, 100% Brakes, No Reverse
Profile #3 (Training Mode): 50% Forward, 100% Brakes, 50% Reverse
Selecting Sport Mode (Profile #1)
1. Connect two fully charged battery
packs to the EVX-2 and turn on your
transmitter.
2. With the EVX-2 off, press and hold
the EZ-Set button until the light
turns solid green, then solid red and
then begins blinking red (indicating
the Profile numbers).
3. When the light blinks red once,
release the EZ-Set button.
4. The light will then turn green and the model is ready to drive.
Selecting Race Mode (Profile #2)
1. Connect two fully charged battery
packs to the EVX-2 and turn on your
transmitter.
2. With the EVX-2 off, press and hold
the EZ-Set button until the light
turns solid green, then solid red and
then begins blinking red (indicating
the Profile numbers).
3. When the light blinks red twice,
release the EZ-Set button.
4. The light will then turn green and the model is ready to drive.
Selecting Training Mode* (Profile #3)
1. Connect two fully charged battery
packs to the EVX-2 and turn on your
transmitter.
2. With the EVX-2 off, press and hold
the EZ-Set button until the light
turns solid green, then solid red and
then begins blinking red (indicating
the Profile numbers).
A B
3. When the light blinks red three
times, release the EZ-Set button.
4. The light will then turn green and the model is ready to drive.
Green to Red to Off One blink Red
Note: If you missed the mode you wanted, keep the EZ-Set button
C D
pressed down and the blink cycle will repeat until a Mode is selected.
Release Solid Green
ADJUSTING THE ELECTRONIC SPEED CONTROL
A
Green to Red to Off
C
Release
A
Green to Red to Off
C
Release
B
Patent Pending Training
Mode (Profile #3) reduces
forward and reverse throttle
by 50%. Training Mode
is provided to reduce the
Two blinks Red
power output allowing
D
beginning drivers to better
control the model. As driving
skills improve, simply change
to Sport or Race Mode for
Solid Green
full-power operation.
Tip For Fast Mode Changes
The EVX-2 is set to Profile 1
B
(Sport Mode) as the default.
To quickly change to Profile 3
(Training Mode), with the
transmitter on and the EVX-2
turned off, press and hold
Three blinks Red
the SET button until the light
D
blinks red three times and then
release. For full power, turn off
the EVX-2 then quickly change
back to Profile 1 (Sport
Solid Green
Mode) by pressing and
holding the SET button until
the light blinks red one time
and then releasing.
*Patent-pending
SUMMIT • 17