Impex Marcy Platinum GS 99 Owner's Manual page 10

STEP 4 (See Diagram 4)
A.) Slide fourteen Weight Plates (#44) onto the rear set of Guide Rods (#9). Make sure the
groves on the Plates all face toward the back of the machine. Insert a Selector Rod (#29)
into the center holes. Slide a Selector Stem (#45) onto the two Guide Rods.
B.) Repeat Procedure A above to install the other fourteen Weight Plates onto the other two
Guide Rods. Make sure the grove on the Plate all face toward the front of the machine.
C.) Place the Upper Frame (#6) onto the Right Vertical Beam (#3), Guide Rods (#9), and the
Rear Vertical Frame (#4).
D.) Secure the Upper Frame (#6) to the Right Vertical Beam (#3) with two M10 x 2 ½" Carriage
Bolts (#85), one 4 3/8" x 1 ¾" Bracket (#73), two Ø ¾" Washers (#99), and two M10 Aircraft
Nuts (#96).
E.) Secure the Upper Frame to each Guide Rod with one M10 x 1" Allen Bolt (#81) and Ø ¾"
Washer (#99).
F.) Attach the Left Vertical Beam (#5) to the Left Base Frame (#2). Secure it with two M10 x 2
½" Carriage Bolts (#85), Ø ¾" Washers (#99), and M10 Aircraft Nuts (#96).
G.) Secure the Left Vertical Beam (#5) to the Upper Frame (#6) and Rear Vertical Frame (#4)
with two M10 x 2 ¾" Carriage Bolts (#84), Ø ¾" Washers (#99), and M10 Aircraft Nuts
(#96).
H.) DO NOT tighten all Nuts and Bolts yet.
9