Polaris Turbo IQ LXT Owner's Manual page 88

OPERATION
Electronic Reverse (PERC 4)
Electronic reverse will activate only when the vehicle is stopped and
engine speed is below 2500 RPM. Maximum vehicle speed when oper-
ating in reverse will be approximately 12 MPH (19 km/h).
WARNING! Improper reverse operation, even at low speeds, may cause loss of
control, resulting in serious injury or death. Damage will occur to the gearcase or
transmission if shifting is attempted when the engine is operating above idle
speed.
• Shift to or from reverse only when the snowmobile is stopped and when
engine speed is at idle.
• Look behind the snowmobile before and while backing.
• Avoid sharp turns.
• Apply throttle slowly.
NOTICE: Engaging the starter when the engine is running WILL result in serious
engine damage, especially if the transmission is in reverse. Never
engage the starter when the engine is running.
Engaging Reverse
1. Stop the snowmobile and
leave the engine idling.
2. Make sure the area behind
your snowmobile is clear.
3. Push the yellow reverse but-
ton on the left-hand control
for one second, then release.
Tip: A reverse light on the instrument panel will indicate that the transmission is
in reverse.
4. Apply the throttle slowly to make sure the transmission is in
reverse.
Tip: If the engine stops running, the transmission will be in forward gear when
it's restarted.
86
Reverse Button