Page 1
™ Cinema Sound Series CSS10 Amplifier/Subwoofer SERVICE MANUAL JBL Consumer Products 250 Crossways Park Dr. Woodbury, New York 11797 Rev1 7/2006...
Page 4
CSS10 Cinema Sound CSS10 150W Powered Sub/ Plate Amp LINE VOLTAGE Yes/No Hi/Lo Line Unit Notes US 120vac/60Hz 108-132 Vrms Normal Operation EU 230vac/50-60Hz 207-264 Vrms Normal operation, MOMS required Parameter Specification Unit QA Test Limits Conditions Notes Amp Section...
Page 5
CSS10 Cinema Sound Power Cons.@rated power 240 Watts @ nom. line voltage 150 Watts @ 4 Ohms nominal line voltage Protection Short Circuit Protection functional Direct short at output Temperature rise should not exceed 35K Thermal Protection 65 deg. C...
Page 6
DOLBY ® DIGITAL OR DTS ® (OR OTHER DIGITAL SURROUND MODE) CONNECTION Frequency Effects channel. your receiver for 5.1-, 6.1- SUBWOOFER RECEIVER Connect this jack to the LFE or 7.1-channel operation as output or subwoofer output appropriate. The front left, LINE LFE OUT on your receiver or amplifier.
Page 7
∂ woofer will be in standby mode (the LED on the front of the CSS10 will be red). When the subwoofer senses an audio signal, it will auto- matically turn on (the LED will be green). If the sub-...
• Check that receiver/ampli- tance or, if that is not possi- ured so that the subwoofer fier is on and a source is ble, visit www.jbl.com. and LFE output are enabled. playing. If there is no sound from the • Switch the Phase switch •...
Page 9
CSS10 Cinema Sound Test Set Up and Procedure Equipment needed: • Function/signal generator/sweep generator • Integrated Amplifier • Multimeter • Speaker cables Initial Control Settings: • Power Switch OFF • Level MIN (Full CCW) • Phase, Auto/On switches do not matter...
Page 10
CSS10 Cinema Sound Item# Part Number Description 249-ABS-05080-0VAE Port Tube (Outer Portion) 249-ABS-05095-0VAE Port Tube (Inner portion) Not Available CSS10 Cabinet Not Available Dacron Filler Not Available CSS10 Amplifier 352-AM04020D210-E Amplifier Screws 316-CU-05174-0VAE JBL Logo 25PR12FZL-DW01 10” (250mm) Woofer DCR = 3.5Ω...