Additional Information - Baby Trend Inertia Horizon Owner's Manual

Additional Information

13.0
Seat Pad and Head Support Pad: For care and maintenance, read
and follow instructions on fabric tags.
To remove Seat Pad / Head Support Pad:
1. Remove the harness shoulder straps from the Car
Seat.
2. Loosen the harness straps by depressing the
Harness Adjuster Button located below the flap
just ahead of the Harness Buckle and pulling on
the harness straps. (Fig. 53-1)
3. Move Head Support into highest position to
remove and re-thread harness straps.
4. Turn the seat over. Locate the Belt Adjuster
Plate near the bottom of the seat. (Fig. 53-2)
Remove both Harness Straps from the Belt
Adjuster Plate. From the front of the seat, pull
the Harness Straps through the shoulder area
slots and seat pad.
5. Unthread the shoulder strap from the
Harness-tie and Buckle Tongues, leaving
the Buckle Tongues in the Buckle. Be sure
to note how they are threaded to assist in
reassembling.
6. Carefully remove the Head Support Pad then
adjust the Adjustable Back to its lowest position.
7. Carefully remove the Sead Pad, do not unthread
the lower portion of the harness from the Car Seat.
8. For care and maintenance see fabric tag.
53-1
A
B
A
B
53-2
53
13.0
WARNING!
DO NOT use the Car Seat Without the Seat Pad.
To install Seat Pad / Head Support Pad:
1. Reinstall Seat Pad /Head Support Pad on
Car Seat only when fabric is completely dry.
2. Place Seat Pad on Car Seat then place
the Head Support Pad, thread the Harness
straps through the Seat Pad bottom slots
and pulling the Buckle through the opening
at the rear of the flap on Pad. Thread
the Harness Straps through Buckle
Tongues and Harness-Tie. (Fig. 54-1)
3. Move Head Support into highest
position to re-thread harness straps.
4. Use the included Belt Threading Tool and thread
the Harness straps through the slots in the
Seat Pad and Head Support Pad. (Fig. 54-2)
5. From the rear of the Car Seat, pull
the Harness Straps through the Slots
until you have enough strap to reach
the Belt Adjuster Plate. (Fig. 54-3)
6. Reassemble the Harness Straps to the Belt
Adjuster Plate. Do the left Harness Strap first,
Additional Information
Harness-Tie
Buckle Tongues
54-1
Belt Threading Tool
54-2
A
A
B
54-3
54