Table of Contents
Advertisement
The date and time are recorded incorrectly.
• Set the correct date and time (page 25).
The aperture value and/or shutter speed flashes when you press the
shutter button halfway down.
• Since the subject is too bright or too dark, it is beyond the available range of
the camera. Adjust the setting again.
The image is whitish (Flare).
Blurring of light appears on the image (Ghosting).
• The picture was taken under a strong light source, and excessive light has
entered the lens. Attach a lens hood (sold separately).
The corners of the picture are too dark.
• If any filter or hood is used, take it off and try shooting again. Depending on
the thickness of the filter and improper attachment of the hood, the filter or
the hood may partially appear in the image. The optical properties of some
lenses may cause the periphery of the image to appear too dark (insufficient
light).
The eyes of the subject come out red.
• Activate the red eye reduction function (page 90).
• Get close to the subject, and shoot the subject within the flash range using
the flash (page 90).
Dots appear and remain on the LCD monitor.
• This is not a malfunction, These dots are not recorded (page 7).
• You may reduce the effect of these issues using the "Pixel mapping"
function.
CD
Set the LIVE VIEW/OVF switch to "LIVE VIEW."
®
Attach the lens cap.
@)
MENU button
---+ ~
3
---+
[Pixel mapping]
---+
[OK]
The image is blurred.
• The picture was taken in a dark location without the flash, resulting in
camera shake. The use of a tripod or the flash is recommended (pages 49,
88).
163
•
o
-
= -
CD
-
e n
The date and time are recorded incorrectly.
• Set the correct date and time (page 25).
The aperture value and/or shutter speed flashes when you press the
shutter button halfway down.
• Since the subject is too bright or too dark, it is beyond the available range of
the camera. Adjust the setting again.
The image is whitish (Flare).
Blurring of light appears on the image (Ghosting).
• The picture was taken under a strong light source, and excessive light has
entered the lens. Attach a lens hood (sold separately).
The corners of the picture are too dark.
• If any filter or hood is used, take it off and try shooting again. Depending on
the thickness of the filter and improper attachment of the hood, the filter or
the hood may partially appear in the image. The optical properties of some
lenses may cause the periphery of the image to appear too dark (insufficient
light).
The eyes of the subject come out red.
• Activate the red eye reduction function (page 90).
• Get close to the subject, and shoot the subject within the flash range using
the flash (page 90).
Dots appear and remain on the LCD monitor.
• This is not a malfunction, These dots are not recorded (page 7).
• You may reduce the effect of these issues using the "Pixel mapping"
function.
CD
Set the LIVE VIEW/OVF switch to "LIVE VIEW."
®
Attach the lens cap.
@)
MENU button
---+ ~
3
---+
[Pixel mapping]
---+
[OK]
The image is blurred.
• The picture was taken in a dark location without the flash, resulting in
camera shake. The use of a tripod or the flash is recommended (pages 49,
88).
163
•
o
-
= -
CD
-
e n
Advertisement
Table of Contents
