Table of Contents
Advertisement
Overview
The NXR-ZGW (FG5791-01) is an Ethernet to ZigBee wireless gateway. The NXR-ZGW features a
10BaseT, half duplex Ethernet port capable of Power over Ethernet (PoE), 16 Mbytes of Flash, 16
Mbytes of SDRAM, and a ZigBee module, and is controlled via a web server interface. The NXR-ZRP
(FG5791-02) is a ZigBee wireless repeater that features 16 Mbytes of Flash, 16 Mbytes of SDRAM, and
a ZigBee module.
NXR-ZGW Specifications
The following table outlines the specifications for the NXR-ZGW.
NXR-ZGW (FG5791-01) Specifications
Dimensions (HWD):
Weight:
Power:
Memory:
Radio Specifications:
Frequency
Operating channels
Modulation technique
Output power
Coverage area
Firmware/Software
Specifications:
Management
IP configuration
Communications
Front Components:
LEDs
Antenna Mount
ID Button
NXR-ZGW/-ZRP
• .906 x 2.500 x 3.424 (23.01 mm x 63.50 mm x 86.96 mm), depth does not
include antenna
• 0.35 lbs (158.75g)
10.5 - 18 VDC; 13.5 (nominal operation voltage), or
Power over Ethernet (PoE) Class 2
• 16 Mbytes of Flash
• 16 Mbytes of SDRAM
IEEE 802.15.4
• 11 - 26
• DSS
• Region/country specific
165 feet (50.2m)
• Built-in browser-based management with User Name/Password
authentication
• Static IP or DHCP client (default is static, 192.168.1.140)
• The NXR-ZGW communicates with a Netlinx master over TCP/IP
encapsulating the ICSP protocol via a physical Ethernet connection. The
ICSP device number can be set via the browser-based management system.
• PWR/STATUS - A green LED that blinks to indicate the device is installed
and communicating properly. Power ON, but no master connection, is
indicated with a solid light; Power OFF is indicated with no light.
• LAN - A green LED indicates an Ethernet connection is established. The LED
blinks to indicate both sending and receiving information via Ethernet.
• RF - The LED is solid when end devices are connected; end devices not
connected is indicated with no LED light; the LED blinks to indicate activity.
A reverse SMA connection that supports a 2.4GHz antenna.
When used in conjunction with NetLinx Studio, sets the device and system
numbers for the NXR-ZGW. Press and hold for approximately 30 seconds to
return the NXR-ZGW to factory default settings.
Overview
1
Advertisement
Table of Contents
