Defining Ipv6 Neighbors Information - Cisco SF200-24 Administration Manual

Configuring IP Information
Management and IP Interfaces
STEP 3
STEP 1
STEP 2
Cisco Small Business 200 1. 1 Series Smart Switch Administration Guide
Click Apply. The tunnel is defined, and the Running Configuration file is updated.

Defining IPv6 Neighbors Information

The IPv6 Neighbors page enables configuring and viewing the list of IPv6
neighbors on the IPv6 interface. The IPv6 Neighbor Table (also known as IPv6
Neighbor Discovery Cache) displays the MAC addresses of the IPv6 neighbors
that are in the same IPv6 subnet as the switch. This is used to verify the
reachability of this neighbor. This is the IPv6 equivalent of the IPv4 ARP Table.
When the switch needs to communicate with its neighbors, the switch uses the
IPv6 Neighbor Table to determine the MAC addresses based on their the IPv6
addresses.
This page displays the neighbors that were automatically detected or manually
configured entries. Each entry displays to which interface the neighbor is
connected, the neighbor's IPv6 and MAC addresses, the entry type (static or
dynamic), and the state of the neighbor.
To define IPv6 neighbors:
Click Administration > Management Interface > (Layer 2) > IPv6 Neighbors
The IPv6 Neighbors page opens.
Select a Clear Table option to clear some or all of IPv6 addresses in the IPv6
Neighbors Table.
• Static Only—Deletes the static IPv6 address entries.
• Dynamic Only—Deletes the dynamic IPv6 address entries.
• All Dynamic & Static—Deletes the static and dynamic address entries IPv6
address entries.
The following fields are displayed for the neighboring interfaces:
• Interface—Neighboring IPv6 interface type.
• IPv6 Address—IPv6 address of a neighbor.
• MAC Address—MAC address mapped to the specified IPv6 address.
• Type—Neighbor discovery cache information entry type (static or dynamic).
• State—Specifies the IPv6 neighbor status. The values are:
16
221