Connection Diagram; Before Connecting The Amplifier - Pioneer GM-5400T Owner's Manual

Bridgeable two-channel power amplifier
Hide thumbs Also See for GM-5400T:
Table of Contents

Advertisement

Section
( Connecting the units
) (~----)
Before connecting the
amplifier
A
WARNING
Secure the wiring with cable clamps or adhe-
sive tape. To protect the wiring, wrap sections
in contact with metal parts in adhesive tape.
Never cut the insulation of the power supply
to feed power to other equipment. Current ca-
pacityof the wire is limited.
Connect male terminal of this wire to the sys-
tem remote control terminal of the car stereo
(SYSTEM REMOTE CONTROL),
The female
terminal can be connected to the auto-anten-
na relay control terminal. If the car stereo
lacks a system remote control terminal. con-
nect the male terminal to the power terminal
via the ignition switch.
®
Speaker output terminals
Please see the following section for speaker
connection instructions. Refer to Connections
when using the speaker input wire on page 8.
@)
Fuse (30 A) x 2
@
Fuse (30 A)
x
2
@
Grommet
@ Rear side
®
Froflt side0
A
CAUTION
Never shorten any wires, the protection circuit
may malfunction.
Never ground speaker wire directly or band to-
gether multiple speakers' negative (8) lead
wires.
If the system remote control wire of the ampli-
fier is connected to the power terminal via the
ignition switch (12 V DC), the amplifier will re-
main on with the ignition whether the car
stereo is on or off, which may exhaust battery
if the engine is at rest or idling.
Connection diagram
~'~?I!j)~l
_ _..,
®
t""--_
t-@
CD
Special red battery wire
RD-223 (sold separately)
After completing all other amplifier connec-
tions, finally connect the battery wire terminal
of the amplifier to the positive ((±») battery
terminal.
@ Ground wire (Black)
RD-223 (sold separately)
Connect to metal body or chassis.
®
Car stereo with RCA output jacks (sold sepa-
rately)
o
External output
®
Connecting wire with RCA pin plugs (sold se-
parately)
®
Speaker input terminal
Please see the following section for speaker
connection instructions. Refer to Connections
when using the speaker input wire on page 8,
m
RCA input jack
®
System remote control wire (sold separately)
m
En

Advertisement

Table of Contents
loading

This manual is also suitable for:

Gm-3400t

Table of Contents