Panasonic PT-D7500E Operating Instructions Manual page 95

8. Insert the power cord plug into the wall outlet and then press the MAIN POWER
switch.
Caution
• If the power does not turn on (power indicator lamp (red) does not turn on) even after turning the
MAIN POWER switch "I", turn the MAIN POWER "
installed correctly, and turn on again.
9. Press the "POWER" (I) button so that a picture is projected onto the screen.
10. Press the "MENU" button to display
the MAIN MENU screen, and then
press the and
the cursor to select "OPTION".
11. Press the "ENTER" button to display
the "OPTION" screen, and then use
the and buttons to select
"LAMP1 RUNTIME" or "LAMP2
RUNTIME".
12. Press and hold the "ENTER" button
on the projector or the remote control
for approximately 3 seconds.
An item "LAMP RESET" will be added.
Note • When you press the "MENU" button,
the lamp reset display disappears.
13. Press the and
for replacement lamp setting.
LAMP1: Replace the LAMP UNIT 1
LAMP2: Replace the LAMP UNIT 2
DUAL: Replace the LAMP UNIT 1 & LAMP UNIT 2
14. Press the "ENTER" button. When
"OK?" is displayed, press the
"ENTER" button.
The used hours of the specified lamp unit will be
reset to zero.
buttons to move
buttons to select
O
", confirm that the lamp unit and door are
MAIN MENU
PICTURE
POSITION
LANGUAGE
OPTION
TEST PATTERN
SIGNAL LIST
:MENU SELECT
ENTER:SUB MENU
OPTION
ID 2
SETTING FRONT-F
LAMP1 RUNTIME 1310h
LAMP2 RUNTIME 1310h
LAMP SELECT DUAL
LAMP POWER HIGH
LAMP COOLING TIME SHORT
RS232C SETTING
RGB2 SELECT RGB1 OUT
OSD POSITION 1
:MENU SELECT
ENTER:INITIALIZE
OPTION
ID 2
SETTING FRONT-F
LAMP1 RUNTIME 1310h
LAMP2 RUNTIME 1310h
LAMP RESET DUAL
LAMP SELECT DUAL
LAMP POWER HIGH
LAMP COOLING TIME SHORT
RS232C SETTING
RGB2 SELECT RGB1 OUT
:NENU SELECT
:CHANGE ENTER:EXECUTE
OPTION
ID 2
SETTING FRONT-F
LAMP1 RUNTIME 1310h
LAMP2 RUNTIME 1310h
LAMP RESET DUAL
LAMP SELECT DUAL
LAMP POWER HIGH
LAMP COOLING TIME SHORT
RS232C SETTING
RGB2 SELECT RGB1 OUT
ENTER:EXECUTE MENU:ESC
OK?
95