Table of Contents
Advertisement
CAUTION:
For proper airflow, the SFP media side of the SAN Switch must face the rear of the rack.
To install the switch in a rack:
1.
Verify that the required parts and hardware are available. See
2.
Choose a mounting location for the switch in the rack.
3.
Attach the rear mounting brackets to the rear rack uprights:
• For HP 10000 series racks, assemble each of the two brackets with two
#10-32 x 1/2-inch Phillips pan-head screws with captive star lock-washers
and two #10 adapter washers, as shown in
• For an HP System/e Rack, install the two rear mounting brackets with
two #10-32 x 1/2-inch Phillips pan-head screws and two #10 alignment
washers, as shown in
Figure 10 Installing the rear mounting brackets (HP 10000 series
racks)
Figure 11 Installing the rear mounting brackets (HP System/e Rack)
NOTE:
Your SAN Switch Rack Mount Kit contains both left rails and right rails.
Figure 11
on page 43.
Table 3
Figure 10
on page 43.
SAN Switch installation guide
on page 36.
43
Advertisement
Table of Contents
