Disassembly Instructions - Mitsubishi Electric MSZ-SF25VE Service Manual

11

DISASSEMBLY INSTRUCTIONS

<"Terminal with locking mechanism" Detaching points>
The terminal which has the locking mechanism can be detached as shown below.
There are two types (Refer to (1) and (2)) of the terminal with locking mechanism.
The terminal without locking mechanism can be detached by pulling it out.
Check the shape of the terminal before detaching.
(1) Slide the sleeve and check if there is a locking lever or not.
Sleeve
Locking lever
MSZ-SF25VE MSZ-SF35VE
OPERATING PROCEDURE
1. Removing the panel
(1) Remove the horizontal vanes.
Removal procedure
Unlock the upper and lower vanes as shown
in using a thin instrument.
Then, remove the horizontal vanes in the
direction of .
Unlock
(2) Remove the screw caps of the panel. Remove the
screws of the panel.
(3) Unhook the lower part ( ) of the panel.
(4) Pull the panel slightly toward you, and then remove
the panel by pushing it upward.
OBH600A
Slide the sleeve.
Pull the terminal while
pushing the locking
lever.
MSZ-SF42VE
Upper and
lower vanes
(2) The terminal with this connector has the
locking mechanism.
Hold the sleeve, and
pull out the terminal
slowly.
Connector
MSZ-SF50VE
NOTE: Turn OFF power supply before disassembly.
Photo 1
Front panel
A
Screws of
the panel
30
PHOTOS
Horizontal vanes