Inspecting The Saw Blade Guard For Proper Operation; Regular Cleaning Of The Saw Blade Guard; Storage; Lubrication - Hitachi C 10RA2 Technical And Service Manual

9-4. Inspecting the Saw Blade Guard for Proper Operation

Before each use of the tool, test the saw blade guard to assure that it is in good condition and that it moves
smoothly. Never use the tool unless the saw blade guard operates properly and unless it is in good mechanical
condition. Ensure the anti-kickback pawls are always sharp so they dig into the workpiece and avoid kickback. If
any damage has occurred, repair it promptly.

9-5. Regular Cleaning of the Saw Blade Guard

Wipe off saw dust attached to the inside of the see-through saw blade guard using a soft cloth. Do not use
solvent (gasoline, thinner etc.), solvents will damage plastic parts.

9-6. Storage

Confirm that the switch is turned OFF, that the power plug has been removed from the receptacle and that the
safety key has been removed and stored in a secure place, after operation of the saw has been completed.
When the saw is not in use, keep it stored in a dry place out of the reach of children.

9-7. Lubrication

Lubricate the following moving parts and rotating parts once a month to keep the saw in good operating condition
for a long time. Use of machine oil is recommended.
Oil supply points: Rotary and moving portion of wheel

9-8. Cleaning

Periodically remove chips and other waste material from the surface of the saw with a damp, soapy cloth.
To avoid a malfunction of the motor, protect it from contact with oil or water.
--- 20 ---