Rear Panel Connections - Cambridge Audio azur DacMagic User Manual

Rear panel connections

Designed in the UK, Made in China
Left
1
Right
Unbalanced
Right — Balanced Output — Left
Output
Unbalanced Audio Outputs
1
Single-ended conventional stereo outputs for connection to the line-level phono/RCA inputs of an
amplifier.
2
Balanced Audio Outputs
The DacMagic also features true balanced (XLR) outputs. This is a higher quality output that can
reject noise and interference with equipment with balanced inputs. These balanced outputs are
ideally suited for connection to the Cambridge Audio 840A or 840E amplifiers. XLR connectors should
be wired as follows:
Pin 1 – Ground; Pin 2 – Hot (in-phase); Pin 3 – Cold (phase-inverted).
3 Digital Outputs
The digital outputs allow a digital recording device to be connected. These outputs loop or pass-
through unprocessed digital audio from the selected digital input. Two types are available (both the
co-axial and the optical are active concurrently and can be used to connect and run equipment at the
same time):
S/P DIF co-axial – to obtain best results, use a high quality 75 ohm digital RCA interconnect cable (not
one designed for normal audio use).
8
DacMagic Upsampling DAC
www.cambridge-audio.com
Digital Outputs
S/P DIF
Co-axial
2
Manufactured in an ISO9001 approved facility
3 4
Digital Input 1
Toslink S/P DIF Toslink
Optical Co-axial Optical
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
2) This device must accept any interference, including interference that may cause undesired operation.
Caution
Serial Number Label Removed
5
6
Digital Input 2
USB In
S/P DIF Toslink
Co-axial Optical
1) This device may not cause harmful interference;
Incorporating Q5 ™
from:
ANAGRAM
TECHNOLOGIES
12V 1500mA
7
Use supplied
PSU only!