Advertisement
O O R R A A N N G G E E ( ( + + ) ) a a c c c c e e s s s s o o r r y y o o u u t t p p u u t t
Connect this wire to the accessory wire in the vehicle that powers the climate control system.
P P I I N N K K ( ( + + ) ) i i g g n n i i t t i i o o n n o o u u t t p p u u t t
Connect this wire to the ignition wire in the vehicle.
P P I I N N K K / / W W H H I I T T E E ( ( + + ) ) o o u u t t p p u u t t t t o o s s e e c c o o n n d d i i g g n n i i t t i i o o n n / / a a c c c c e e s s s s o o r r y y c c i i r r c c u u i i t t
Connect this wire to the second ignition or accessory wire in the vehicle (selectable menu feature 2-9).
R R E E D D / / W W H H I I T T E E 1 1 2 2 V V i i n n p p u u t t
If additional current capacity is needed cut this wire, add a fuse adaquate for the circuit to be supplied, and
connect to an additional 12V source.
a a u u x x i i l l i i a a r r y y h h a a r r n n e e s s s s ( ( H H 2 2 ) ) w w i i r r e e c c o o n n n n e e c c t t i i o o n n g g u u i i d d e e
H H 2 2 / / 1 1 V V I I O O L L E E T T / / B B L L A A C C K K ( ( - - ) ) c c h h a a n n n n e e l l 4 4 o o u u t t p p u u t t
This wire provides 200 mA programmable output. (See Feature Descriptions section of this guide.)
H H 2 2 / / 2 2 G G R R E E E E N N / / W W H H I I T T E E f f a a c c t t o o r r y y r r e e a a r r m m o o u u t t p p u u t t
This wire sends a negative pulse every time the remote start shuts down or the doors are locked. This can be used
to pulse the arm wire of the vehicle's factory anti-theft device. Use a relay to send a (-) or (+) pulse to the arm
wire.
H H 2 2 / / 3 3 G G R R A A Y Y / / B B L L A A C C K K ( ( - - ) ) d d i i e e s s e e l l w w a a i i t t - - t t o o - - s s t t a a r r t t b b u u l l b b i i n n p p u u t t
Connect this wire to the wire in the vehicle that sends the signal to turn on the WAIT-TO-START bulb in the dash-
board. In most diesels the wire is negative (ground turns on the bulb) and the GRAY/BLACK can be directly
connected to the wire in the vehicle. If the vehicle uses a positive wire (12V to turn on the bulb) a relay must
be used to change the polarity. (See Finding the Wait-To-Start Bulb Wire For Diesels section of this guide.) Here
are some common colors of this wire:
■ Chevrolet and GMC trucks: Light Blue or Dark Blue
■ Ford Trucks: Black/Pink
■ Dodge Ram Trucks: Orange/Black or Black/Orange
N N O O T T E E : : A 1-amp diode must be installed in line on the factory wire between the wait-to-start indi-
cator and the ECM. (See the following diagram for details.)
© 2005 Directed Electronics—all rights reserved
1 1 7 7
Advertisement
