Shooting Still Images/Movies - Sony Cyber-shot DSC-W370 Instruction Manual

Digital still camera
Hide thumbs Also See for Cyber-shot DSC-W370:
Table of Contents

Advertisement

The remaining charge indicator is incorrect.
• This phenomenon occurs when you use the camera in an extremely hot or cold location.
• A discrepancy arose between the remaining charge indicator and the actual remaining battery charge.
Fully discharge the battery pack once, then charge it to correct the indication. The indicator may not
be accurate depending on the conditions of use.
• Battery capacity decreases over time and through repeated use. When the operating time per charge
decreases markedly, the battery pack needs to be replaced (page 123). Purchase a new battery pack.
The CHARGE lamp flashes while charging the battery.
• Remove and reinsert the battery pack, making sure it is installed correctly.
• The temperature may be inappropriate for charging. Try charging the battery pack again within the
proper charging temperature range (10 °C to 30 °C (50 °F to 86 °F)).
• Refer to page 124 for details.

Shooting still images/movies

Cannot record images.
• Check the free capacity of the internal memory or memory card. If it is full, do one of the following:
– Delete unnecessary images (page 36).
– Change the memory card.
• You cannot record images while charging the flash.
• For recording movies, it is recommended that you use a memory card of 1 GB or larger.
• Set [Demo Mode] to [Off] (page 78).
Smile Shutter function does not work.
• No image is shot if a smiling face is not detected.
• Set [Demo Mode] to [Off] (page 78).
Anti-blur function does not work.
• The anti-blur function may not work properly when shooting night scenes.
• Shoot after pressing the shutter button halfway down.
Recording takes a long time.
• When the shutter speed becomes slower than a certain speed in low light conditions, the NR (Noise
Reduction) slow shutter function is activated automatically to reduce the image noise. Under such
conditions, recording takes a long time.
• The Anti Blink function is working. Reset [Anti Blink] to [Off] (page 57).
The image is out of focus.
• The subject is too close. When shooting, make sure to position the lens farther away from the subject
than the shortest shooting distance (approximately 10 cm (4 inches) (W)/100 cm (3 ft 3 3/8 inches)
(T) from the lens).
(Twilight),
(Landscape) or
shooting still images.
(Fireworks) mode is selected in the Scene Selection when
110
GB

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents