Connect To An Apple Macintosh System - IBM 72H9623 User Manual

Connecting the Monitor

Connect to an APPLE Macintosh System

Figure shows the connection to an Apple Macintosh, using a separately
purchased adapter. For more information on adapter requirements, contact your
IBM authorized dealer for PartNumber 96G2694.
1
Power OFF both the monitor and the MAC.
2
Locate the appropriate MAC to VGA adapter block at your local computer store.
This adapter changes the high density 3 row 15 pin VGA connector to the
correct 15 pin 2 row connection to mate with your MAC. Attach the other end of
the signal cable to the side of the adapter block with 3 rows.
3
Connect the attached adapter block/signal cable to the video output on your
MAC.
4
Connect the plug from the AC-DC adapter into the connector on the display
1
unit. Connect one end of the AC power cord into the AC-DC adapter.
the other end into a properly grounded AC outlet.
5
Power ON the MAC, then the monitor.
6
If you see the Check Signal Cable message, check the signal cable and
connectors.
7
After using the system, power OFF the monitor, then the MAC.
Note : If you see the "Outside Range Limits" message, check to make sure your system is set
to one of the factory preset modes.(See pages A12 and A13)
3
Power Cord
3
Adapter 15P
1
Signal Cable
AC-DC adapter
2
A4
2
Plug
D-15P