Diagnostic Mode - Yamaha YP400T, YP400V, YP400W Service Manual

01 70 70 01
FUEL INJECTION SYSTEM
EAS00905

DIAGNOSTIC MODE

It is possible to monitor the sensor output data
or check the activation of actuators without
connecting the measurement equipment by
simply switching the meter indication from the
normal mode to the diagnostic monitoring
mode.
Setting the diagnostic mode
1. Turn the main switch to "OFF" and set the
engine stop switch to "OFF".
2. Disconnect the wire harness coupler from
the fuel pump.
3. Simultaneously
"SELECT" and "RESET" buttons, turn the
main switch to "ON", and continue to press
the buttons for 8 seconds or more.
NOTE:
• All displays on the meter disappear except
the clock and tripmeter displays.
• "dIAG" appears on the LCD meter.
4. Press the "SELECT" button to select the CO
adjustment mode "Co" or the diagnostic
mode "dIAG".
5. After selecting "dIAG", simultaneously press
the "SELECT" and "RESET" buttons for 2
seconds or more to execute the selection.
6. Select the diagnostic code number that
applies to the item that was verified with the
fault
"SELECT" and "RESET" buttons.
NOTE:
• The diagnostic code number appears on the
LCD meter (01-70).
• To decrease the selected diagnostic code
number, press the "RESET" button. Press
the "RESET" button for 1 second or longer to
automatically decrease the diagnostic code
numbers.
• To increase the selected diagnostic code
number, press the "SELECT" button. Press
the "SELECT" button for 1 second or longer
to automatically increase the diagnostic code
numbers.
7 - 7
FI
press and
code number by
hold the
pressing the