Kyocera FS-1025MFP Operation Manual page 39

Originals Not Supported by the Document Processor
How to Load Originals
IMPORTANT Before loading originals, be sure that there are no originals left on the original eject table. Originals left
on the original eject table may cause the new originals to jam.
• Soft originals such as vinyl sheets
• Transparencies such as OHP film
• Carbon paper
• Originals with very slippery surfaces
• Originals with adhesive tape or glue
• Wet originals
• Originals with correction fluid which is not dried
• Irregularly shaped (non-rectangular) originals
• Originals with cut-out sections
• Crumpled paper
• Originals with folds (Straighten the folds before loading. Failure to do so may cause the
originals to jam.)
• Originals bound with clips or staples (Remove the clips or staples and straighten curls,
wrinkles or creases before loading. Failure to do so may cause the originals to jam.)
1
Adjust the original table size.
2
Load originals.
Put the side to be scanned face-up. Slide the leading edge into the document processor as
far as it will go.
Note Ensure that loaded originals do not exceed the level indicator. Exceeding the
maximum level may cause the originals to jam (see the figure).
Confirm that the original width guides exactly fit the originals. If there is a gap,
readjust the original width guides. The gap may cause the originals to jam.
2-19
Preparation