Table of Contents
Advertisement
Windsor High Efficiency Wood Insert
Clearance to Combustible Constructions
1. Remove all boxes of firebricks and any packaging
from inside the appliance.
2. Clean out the masonry fireplace ensuring the ashes
are placed in a metal container.
3. Remove or lock open the damper plate in the ma-
sonry fireplace.
4. Contact local building, fire officials or authorities
having jurisdiction about permits, restrictions and
installation inspection requirements in your area.
5. The insert must be installed in compliance with the
minimum clearances to combustible constructions
and floor protection stated on appliance certifica-
tions label (located on back of unit) and listed below.
A
Figure 2
Clearance to Combustibles
4
Installation
Mantel
Top Trim
Face Plate
Floor Protector
Clearance to Combustible Constructions
ST1022
A
Unit to Side Wall
DW2500 clearances
B
Unit to Top Trim
10/08
C
Unit to Side Trim
D
Unit to Mantel
E
Floor Protector Front
F
Floor Protector Side
Refer to Page 6 for Floor Protection requirements
Refer to Page 5 for further instructions about floor
protection.
fAILURE to foLLoW tHESE MInIMUM CLEAR-
AnCES REQUIREMEntS MAy RESULt In An Un-
SAfE InStALLAtIon.
6. Install the refractory bricks. (Fig. 3)
7. Install faceplate onto insert. (Page 7) The trim
should fit against the face of the fireplace. If this is
not a good fit, a 2" (51 mm) wide strip of fiberglass
insulation can be used to insure a good fit.
D
B
C
Floor
F
12" (305 mm)
10" (254 mm)
10" (254 mm)
17" (430 mm)
16" (405 mm) in the US
18" (457 mm) in Canada
8" (203 mm)
12"
(305 mm)
Max
E
ST1022
30005129
Advertisement
Table of Contents
