This manual describes the installation and operation of the Model WR2500X02 non-
catalytic wood heater. This heater meets US Environmental Protection Agency emis-
sion limits for wood heaters. Under specific conditions this heater has been shown to
5129
deliver heat at rates ranging from 9,500 to 57,800 BTU/hr.
WR2500X02 cover
SAfEty notICE
Read this entire manual before you install
and use your fireplace insert. If not properly
installed, a house fire may result. to reduce
the risk of fire, follow the installation instruc-
tions. failure to follow instructions may re-
sult in property damage, bodily injury or even
death. Contact local building, fire officials or
authorities having jurisdiction about permits,
restrictions and installation inspection re-
quirements in your area.
this unit is not mobile home approved.
This stove is listed by OMNI-Test Laboratories of Port-
land, Oregon to meet UL1482 for the US and ULC-S628
for Canada.
Do not Discard this Manual: Retain for future Use
Windsor EPA Certified
High Efficiency Wood
Insert
Model WR2500X02
owner's Manual
this appliance is manufactured for a 6"
(152 mm) Dia. chimney connection. (Refer
to Page 7)
30005129 3/10 Rev. 1