Inspecting And Replacing Anode(S) - Yamaha VZ200R Owner's Manual

ing device, inject the gear oil into the
gear oil drain screw hole.
Recommended gear oil:
Hypoid gear oil SAE#90
Gear oil quantity:
1.050 L (1.110 US qt, 0.924 Imp.qt)
7. Put a new gasket on the oil level plug.
When the oil begins to flow out of the oil
level plug hole, insert and tighten the oil
level plug.
Tightening torque:
9 Nm (0.9 kgf-m, 6.6 ft-lb)
8. Put a new gasket on the gear oil drain
screw. Insert and tighten the gear oil
drain screw.
Tightening torque:
9 Nm (0.9 kgf-m, 6.6 ft-lb)
9. Securely install the cooling water inlet
covers on both sides of the gear case
using the bolt and nut removed earlier.
Tightening torque:
5 Nm (0.5 kgf-m, 3.6 ft-lb)
EMU29313

Inspecting and replacing anode(s)

Yamaha outboard motors are protected from
corrosion by sacrificial anodes. Inspect the
external anodes periodically. Remove scales
from the surfaces of the anodes. Consult a
Yamaha dealer for replacement of external
anodes.
ECM00720
NOTICE
Do not paint anodes, as this would render
them ineffective.
ZMU02364
TIP:
Inspect ground leads attached to external
anodes on equipped models. Consult a
Yamaha dealer for inspection and replace-
ment of internal anodes attached to the pow-
er unit.
Maintenance
ZMU01901
ZMU01902
73