Bosch Dishwasher Installation Instructions Manual page 10

Figure 12
Junction Box
8
Dishwasher Preparation
B
A
Junction
Box Cover
Figure 13
D
Figure 14
DISHWASHER PREPARATION (continued)
Removing the Toe Panel
Regular Toe Panel
The toe panel is loosely attached with tape. Remove the
tape and pull the toe panel away from the dishwasher. Set
the toe panel aside. It will be reinstalled later.
SHY66 and SHX99A Base and Toe Panel
The base and toe panel are in place on the dishwasher, but
are not attached. Remove the toe panel first, as shown in
Figure 12, letter A, then remove the base, as shown in
Figure 12, letter B
Installing the 90° Elbow Fitting
NOTE: The 90° elbow fitting is not supplied with the
dishwasher, and must be purchased separately. If the
dishwasher's hot water supply line is to be copper tubing,
make certain the elbow has a compression fitting.
Apply Teflon tape or other pipe sealant when required.
Orient the hot water supply connection leg of the elbow
toward the channel opening in the dishwasher base.
Junction Box Preparation
1) Remove junction box cover, Figure 13, by lifting the
junction box cover up and off.
2) Remove the strain relief plate by removing the screw at
the back of the junction box, as shown in Figure 14, letter
D and sliding the strain relief plate out.
3) Set the junction box cover, strain relief plate, and screw
aside. They will be re-installed later.