Advertisement
When the control knob is turned ON, gas will flow into the burner. The solid state igniter
will click until the gas is ignited. (Note: All burner igniters will spark regardless of which
burner is being operated.)
If the burner flame should go out, the automatic reignition
system will automatically
spark to reignite that burner.
This feature is provided as a
convenience.
It is not intended to be interpreted as a safety feature.
A properly adjusted burner with clean ports will light within a few seconds.
The cone-
shaped flame will be clear blue in color with a clearly defined inner cone. There should
be no trace of yellow in the flame. Ifthe burner flame is yellow, lifts off the ports, or is noisy,
the air/gas mixture may be incorrect. Therefore, contact a service technician to make the
needed adjustment.
The infinite surface controls provide flexibility in heat setting selection. (See page 12)
In case of prolonged power failure, you can manually light the surlace burner by holding
alighted match nearthe burner ports and slowly turning the control knob counterclockwise
(after depressing) to the Hi setting.
Note:
Do not leave cooktop unattended when cooking during a power failure.
The
automatic reignition feature of your cooktop will not operate during a power
failure.
Note:
During a power failure, there is no fan so smoke and condensation can gather.
11
Advertisement
