Wallpaper Removal - WAGNER Power Steamer 905 Owner's Manual

Cooling / Refilling:
Follow these steps whenever you are finished or need to refill the container.
1. Shut the unit OFF.
2. Activate trigger until all pressure has been released.
3. Unplug power cord.
4. Allow steamer to cool for at least twenty (20) minutes.
5. Once unit has sufficiently cooled, repeat steps 3-5 in Setup to continue. If finished steaming, drain remaining water from
the container. NEVER store the unit with water in the container.

Wallpaper Removal:

1. For best results, use a scoring tool
or a putty knife and gently score
the wallpaper in a crisscross
pattern before removal. The
perforations will allow the steam to
penetrate the wallpaper.
Steam Cleaning - General Notes:
Using Steam on Delicate Materials
Always check the suitability of materials before steam cleaning. Steam is being generated at temperatures in excess of 212ºF
(100ºC). Do not use on any surfaces that cannot withstand this temperature. Always test a small area of the material, preferably
an area that is normally out of view. Do not soak materials being cleaned. Only a light application of steam is required. See
below for more information on steam cleaning.
DO NOT attempt to use the steam plate included with this unit as a cleaning device. The steam plate is designed
for wallpaper removal only. This unit is not recommended to be used on self-adhesive vinyl tiles.
Pressurized steam may bounce back off cleaning surface.
• Using the cleaning accessories generally require less water than wallpaper removal. Using less water will decrease time it
takes for the unit to make steam.
• Activate the trigger as needed for sufficient steam supply. Use the soft bristles to brush away dirt, grease, unwanted dried
paint, etc. DO NOT over-scrub the surface unless you are cleaning tiles or stone.
• Use only clean tap water or distilled water when using the steamer. No detergents or any other additives are needed.
• When cleaning upholstery or clothing, DO NOT soak the material. Try cleaning an inconspicuous area that is normally not in
view and wait 24 hours before checking whether the material has been affected. If material has been adversely affected, DO
NOT CONTINUE!
2. To remove wallpaper, hold the steam
plate flat against the scored wallpaper
and hold for 15-20 seconds. Move the
steam plate to a new section and
remove the steamed section with the
scraper blade.
DO NOT operate the steamer
once the water container is
empty. Make sure to wear
gloves and eye protection.
5 English