Table of Contents
Advertisement
Troubleshooting
Check
Is an extension cable being used?
(Only when projecting computer image sig‐
nals)
Are the Sync. and Tracking settings adjusted
correctly?
(Only when projecting computer image sig‐
nals)
Is the correct resolution selected?
Part of the image is truncated (large) or small
Check
Is the correct Aspect selected?
Is the image Position adjusted correctly?
(Only when projecting computer image sig‐
nals)
Is the correct resolution selected?
Is the 3D Format set to something other than
Auto?
Image colors are not right
Check
Is the image signal format setting correct?
Are the cables connected correctly?
Is the contrast adjusted correctly?
Is the color adjusted correctly?
If an extension cable is used, electrical interference may affect
the signals.
The projector uses automatic adjustment functions to project at
the optimum status. However, depending on the signal, some
may not be adjusted correctly even after performing self correc‐
tions. If this happens, adjust the Tracking and Sync. settings
from the Configuration menu.
Set the computer so that the signals being output are compatible
with the projector.
p.74
s
Press the
button, and then select the Aspect that matches
the input signal.
Signal - Aspect
s
Adjust the Position setting from the Configuration menu.
Signal - Position
p.47
s
Set the computer so that the signals being output are compatible
with the projector.
p.74
s
Unless the 3D format of the AV device and 3D Format of the
projector are the same, part of the image may not be displayed.
Check that Auto is set during 3D video projection.
3D Setup - 3D Format
p.47
When Video is input
If nothing is projected even when Video Signal is set to Auto
from the Configuration menu, set the signal that matches the
connected device.
Extended - Input Signal - Video Sig‐
s
nal
p.51
When PC is input
If nothing is projected even when PC Signal is set to Auto from
the Configuration menu, set the signal that matches the con‐
nected device.
Extended - Input Signal - PC Signal
s
Check that all the cables required for projection are securely
connected.
p.17
s
For the Video and PC ports, make sure the connector is the same
color as the cable port.
s
Adjust the Contrast setting from the Configuration menu.
Image - Contrast
p.46
s
Adjust the Advanced setting from the Configuration menu.
Image - Advanced
p.46
s
62
Remedy
Signal - Tracking/Sync.
s
Remedy
p.47
s
Remedy
p.17
p.47
Signal -
p.51
Advertisement
Table of Contents
