MTD 450 Series Operator's Manual page 16

Secondary Clutch Cable Adjustment
If additional adjustment is necessary after the primary
adjustment from the Assembly & Set-Up section can no longer
be used, the secondary adjustment can be performed as follows:
NOTE: See
1. Remove the belt cover as instructed the Belt Replacement
page 14.
2. Locate the spring at the end of the cable. See Fig. 7-3.
3. Loosen the upper nut, then tighten or loosen the lower nut
until the proper tension is reached.
4. Once the proper tension is reached, re-tighten the upper
nut to secure the cable.
Off-Season Storage
If the tiller will not be used for a period longer than 30 days, the
following steps should be taken to prepare the tiller for storage.
• Clean the exterior of the engine and the entire tiller
thoroughly. Lubricate the tiller as described in the
Lubrication instructions.
• Using a pressure washer to clean your tiller is not
recommended. The washer may cause damage to the
electric components, spindles, pulleys, bearings or the
engine. Using a pressure washers will result in shortened
life and reduce serviceability.
• Refer to the Engine Operator's Manual for the correct
engine storage instructions.
• Wipe the tines with an oiled rag to prevent rust.
• Store the tiller in a clean, dry area. Do not store next to
corrosive materials, such as fertilizer.
NOTE: When storing any type of power equipment in an
unventilated area or metal storage shed, care should be taken
to rustproof the equipment. Using a light oil or silicone, coat the
equipment and especially any springs, bearings, and cables.
16 S 7— S
ection ervice
Upper Nut
Lower Nut
Idler Pulley Bracket
Figure 7-3