Carrier RAV-SP180UT-UL Service Manual page 46

No. Item
12 Louver control <<Selection of Swing mode>>
(Continued):
• For the Swing mode, the following three types of modes are
In case of 4-way
Discharge
Cassette type
• Three types of the swing modes can be also selected and set
• In case of selecting the Swing mode, "Dual swing" or
<<Louver lock (Louver fix)>>
• For the air direction setup for each discharge port, the louver
• An arbitrary air direction of an arbitrary louver can be
• The louver lock can be set by registering the SET DATA to
Outline of specifications
selectable and settable by keeping Swing/Direction
button pushed for 4 seconds or more on the remote controller.
Q
Standard (4 pieces: same phase) swing
→ Data: [0001 (At shipment)]
When Swing operation is selected, four louvers align at the
horizontal discharge position and then start the Swing
operation at the same time.
R
Dual swing → Data: [0002]
When operation is selected, the louvers of louver No. [01]
and [03] move to the horizontal discharge position, the
louvers of louver No. [02] and [04] move to the downward
discharge position and then start the Swing operation at
the same time.
S
Cycle swing → Data: [0003]
When operation is selected, the louver No. [01] moves to
the horizontal discharge position, [03] to the downward
discharge position, [02] and [04] to the middle position and
then start the Swing operation at the same time.
by the SET DATA of CODE No. (DN) [F0].
"Cycle swing", the following numerals is displayed at the
center of the remote controller screen for approx. 3 seconds
when SWING/FIX button was pushed to select [SWING].
(No display for the standard swing)
Alternate lighting
(0.5 sec.)
Dual swing
position can be locked during the normal operation.
registered and set by keeping
4 seconds or more on the remote controller.
CODE No. (DN) [F1] to [F4] according to the following table.
CODE No. Objective louver No.
F1 01
F2 02
F3 03
F4 04
SWING/FIX
Alternate lighting
(0.5 sec.)
Cycle swing
button pushed for
UNIT LOUVER
SET DATA
0000: Release (At shipment)
0001: Horizontal discharge position
~
0005: Downward discharge position
– 46 –
Remarks
Carry out setting
operation during stop
of the unit; otherwise
the unit stops operation.
For the setting
operation, refer to [How
to set up type of swing]
in Section
"10. SETUP AT
LOCAL SITE AND
OTHERS".
(Page 116 to 130)
Flashing showing the
Swing mode is not
indicated.
Carry out setting
operation during stop of
the unit; otherwise the
unit stops operation.