Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for Prime Security AMX78
Summary of Contents for Prime Security AMX78
- Page 1 AMX78(3) Owner's Manual 0399...
- Page 2 AMX78(3) Owner's Manual 0399...
- Page 3 Congratulations on your purchase of the AMX78 vehicle security system manufactured by Prime Security. To fully benefit from the capabilities of your AMX78 system, we encourage you to read the Owner’s Manual thoroughly. If you have any problems or questions regarding your system, consult the dealer from whom you purchased this product.
-
Page 4: Valet Switch
(See “User-Programmable Features” on page 9). This switch can only be controlled with the use of your ignition key. NOTE: Be sure to have your dealer show you where the valet switch is located. AMX78(3) Owner's Manual 0399... -
Page 5: Operating Your System
The parking lights will flash twice, the doors will lock, the starter will be disabled and the LED will flash slowly. Silent Disarm Indications The parking lights will flash once, the doors will unlock, the starter will be enabled and the LED will turn off. AMX78(3) Owner's Manual 0399... -
Page 6: Interior Light Illumination
“ON” or the engine is started, and will unlock when the ignition key is turned “OFF.” This feature can be programmed ON or OFF. (See the “Programming Table for System Features” on page 9.) AMX78(3) Owner's Manual 0399... -
Page 7: Protected Valet Mode
If you have the optional Trunk Release installed, simply press the remote control TRUNK button for 1-2 seconds to activate your vehicle electronic trunk release. The trunk will “pop” open (may require an optional relay). AMX78(3) Owner's Manual 0399 Status System is disarmed... -
Page 8: Previous Intrusion Alert
“ON,” the LED will flash in cycles to specifically identify which zone triggered the alarm. 1 flash...1 flash... 2 flashes...2 flashes... 3 flashes...3 flashes... AMX78(3) Owner's Manual 0399 *Requires additional module. Zone Impact sensor Hood/trunk trigger... -
Page 9: Alarm State Memory
2 chirps, 2 flashes 2 chirps and 2 flashes, then 4 chirps and 4 flashes 3 chirps, 3 flashes 4 chirps, 4 flashes AMX78(3) Owner's Manual 0399 Explanation Disarming of the alarm Arming of the alarm Armed and there is a sensor malfunction... -
Page 10: User-Programmable Features
6. Follow the “Secondary Action.” You will hear a number of chirps to confirm that you have changed the setting of that feature. 7. Turn the ignition key to the “OFF” position. 8. Repeat steps 1-7 for any other feature you wish to program. AMX78(3) Owner's Manual 0399... - Page 11 One-Step Code — Learning Instant Code Deletion AMX78(3) Owner's Manual 0399 # of Sec on dary Ac tion Wait 3 seconds, the siren chirps once for Active or twice for Passive. Wait 3 seconds, the siren chirps once for OFF or twice for ON.
- Page 12 AMX78(3) Owner's Manual 0399...