Log Placement - Napoleon GVFS20P Installation And Operating Instructions Manual

4.4

LOG PLACEMENT

LOGS MUST BE PLACED IN THEIR EXACT LOCATION IN THE APPLIANCE. DO NOT MODIFY THE
PROPER LOG POSITIONS, SINCE APPLIANCE MAY NOT FUNCTION PROPERLY. DELAYED IGNITION
AND CARBON / SOOT DISTRIBUTION THROUGHOUT THE LIVING AREA MAY OCCUR.
DO NOT PLACE CHARCOAL EMBERS, VERMICULITE OR CHARCOAL LUMPS ON THIS BURNER.
ALL PREVIOUSLY APPLIED LOOSE MATERIAL (GLOWING EMBERS) MUST BE REMOVED PRIOR TO
DO NOT CHANGE OR SUBSTITUTE THE GLOWING EMBER MATERIAL PROVIDED WITH THE
APPLIANCE. IF REPLACING, USE ONLY REPLACEMENT GLOWING EMBERS AVAILABLE FROM
FAILURE TO FOLLOW THESE INSTRUCTIONS WILL ADVERSELY EFFECT THE APPLIANCE'S
PERFORMANCE AND MAY RESULT IN CARBON / SOOT DEPOSITS INSIDE THE APPLIANCE AND ON
In order to assemble the log set, the screen and cast front must be removed, see Cast Front / Screen Removal
in the Finishing section of this manual.
A. Place the rear log, as shown, onto the rear log support brackets. Bend the bracket on the right side to
help retain the rear log against the back of the fi rebox.
B. Place the hole in the underside of log #2 onto
the locating screw, on the left side of the
burner. The fi bre burner is formed to cradle
the centre of the log.
POSITIONING THE LOGS IMPROPERLY WILL CAUSE FLAME IMPINGEMENT AND CARBONING.
THE LOGS ARE FRAGILE AND SHOULD BE HANDLED WITH CARE.
YOUR LOCAL AUTHORIZED DEALER / DISTRIBUTOR.
SURROUNDING SURFACES.
WARNING
!
REAPPLICATION.
C. Place the hole in the underside of log #3 onto
the locating screw, on the right side of the
burner. The bottom branch of log #3 sits in
front of, and against, the right end of log #2.
D. Reinstall the screen & front.
13
76.2B
W415-0559 / C / 10.04.10