Operating Mode - PROEL PLST15H User Manual

OPERATING MODE

Manual mode Manual mode Manual mode Manual mode
- Make sure the power supply is sufficient for the power consumption of
the
- lamps before power up. Otherwise the power lines and the projectors
might be damaged.
- There are two knobs on upside of unit to adjust the speed and the
intensity of flashing.
- Rotate the knobs one by one to set the desired effect.
- On the backside, there are the analogic input and the analogic output.
- Is it possible to connect a remote controller (PROEL Code: PLCD1 or
PLSQST) to the Analogic Input plug.
- The unit can be connected in series with other projectors by means of
cable with Jack connectors.
DMX Mode DMX Mode ( ( ( ( only for only for PLSTHDX)
DMX DMX Mode Mode only for only for
- On the backside of the projector there is a group in switches.
- To activate the DMX mode, turn the switch no.10 on.
- Use the switches 1-9 to set the desired DMX address.
- Connect a common DMX controller to the projector by using the XLR
Input socket positioned on the rear.
- The PLST15HDX has two DMX channels to adjust the speed and the
intensity and of flashing.
PLSTHDX)
PLSTHDX) PLSTHDX)
9