Gas Equipment Start-Up - Trane GMND-SVX01B-EN Installation, Operation And Maintenance Manual

Start-Up

Gas Equipment Start-Up

Customer _____________________________________________
Type of Equip:
Serial Number: _________________________
Name Plate Voltage: ____________________
Type of Gas: Natural
 Are all panels, doors, vent caps in place?
 Has the unit suffered any external damage?
 Does the gas piping and electric wiring appear to be installed in a professional manner?
 Has the gas and electric been inspected by the local authority having jurisdiction?
 Is the gas supply properly sized for the equipment?
 Were the installation instructions followed when the equipment was installed?
 Have all field installed controls been installed?
 Do you understand all the controls on this equipment? If not, contact your wholesaler or rep. (DO NOT START
this equipment unless you fully understand the controls.)
GENERAL
With power and gas off.
 Make certain all packing has been removed.
 Tighten all electrical terminals and connections.
 Check all fans and blowers for free movement.
 Check all controls for proper settings.
 Check all set screws on blowers and bearings.
 Check belt tightness.
BLOWER
With power on and gas off.
 Check voltage L1 _____ L2 _____ L3 _____
 Check rotation of main .
 Check motor amps L1 _____ L2 _____ L3 _____
 Blower RPM _____________
 Check air filters. (Record quantity & size.)
Remarks: _____________________________________________________________________________________________________
_______________________________________________________________________________________________________________
_______________________________________________________________________________________________________________
30
Pre-Inspection Information with Power and Gas Off
Duct Furnace
Model Number: _____________________________
Name Plate Amperage: ______________________
LP Tank Capacity:
Job Name & Number _________________________
_______ lb Rating:
_______ kg
Damage ______________________________
GAS HEATING
With power and gas on.
 Inlet gas pressure. ____ in. wc or ____ kPa
 Pilot and main burner ignition.
 Manifold gas pressure. ____ in. wc or ____ kPa
 Cycle firestat and/or freezestat.
 Check electronic modulation. Set at: __________
 Cycle and check all other controls not listed.
 Check operation of remote panel.
 Entering air temp. _____ °F or ____ °C
 Discharge air temp. (high fire) ____ °F . or ____ °C
 External static pressure _________ in. wc
_______ Btu @ ____ °F
________ kW @ ____ °C
GMND-SVX01B-EN