Preinstallation Information; Getting Started; What You Will Need To Get Started - Monessen Hearth DIS33G Installation And Operating Instructions Manual

PREINSTALLATION INFORMATION

•
Handle the gas log burner assembly by
the grate only. Do not pick the unit up by
the burners.
•
Gloves are recommended when handling
ceramic fiber logs to prevent skin irritation
from loose fibers. Logs are fragile —
handle with care.

GETTING STARTED

Make sure you have received all parts
Check your packing list to verify that all listed parts have
been received. You should have the following:
•
Installation/Operating instructions
•
Black Louvers (5)
•
33" unvented gas heater with brick panels.
•
Canopy
•
Volcanic rock and rock wool
•
Two (2) anchoring screws
•
Mounting screws for canopy
•
Log box (refer to installation instructions)
Accessory face plates available to finish the insert.
•
DIFACESM Black small face 33"H x 43"W
•
DIFACELG Black large face 36"H x 50"W
Accessories include brass trim and mounting hardware
The millivolt controlled version of this heater is the only
style designed to be operated with optional devices for
ON/OFF functions. The following options may be used
with the milli-volt controlled heater. These options are not
packaged with the log set.
•
Hand held Remote with Receiver
•
Wall switch with 15' wire.
•
Wall T-stat with 15' wire.
•
Hand held Thermostat Remote with Receiver
•
Thermostat Sensor
Carefully inspect the contents for shipping damage. If any
parts are missing or damaged, immediately inform the
dealer from whom you purchased the appliance. Do not
attempt to install any part of the appliance unless you have
all parts in good condition.
23D8020
DIS33G Vent Free Gas Fireplace System
Do not install the heater:
•
Where curtains, furniture, clothing, or
other flammable objects are less than
42" from the front of the heater.
•
In high traffic areas.
•
In windy or drafty areas.
WHAT YOU WILL NEED FOR INSTALLATION
You must have the following items available before pro-
ceeding with installation...
•
External regulator (for propane / L.P.G. and 1/2 lb.
Natural Gas Systems only)
•
Piping which complies with local codes
•
Sediment trap
•
Tee joint
•
Pipe wrench or appropriate size crescent wrench
set
•
Phillips head screwdriver
•
Drill with 5/32" bit
•
Optional face plate kit.
•
Manual shutoff valve
•
Optional trim kit for installation into wall or free stand-
ing mantel without three piece faceplate
•
Pipe sealant approved for use with propane / LPG
(Resistant to sulfur compounds)
If the area in which the heater may be
operated does not meet the required volume
for indoor combustion air, combustion and
ventilation air shall be provided by one
of the methods described in the National
Fuel Gas Code, ANSI Z223.1/NFPA 54, the
International Fuel Gas Code or applicable
local codes.
7