Whirlpool 30” Installation Instructions page 3

Electrical connection
Electrical ground is required on this
appliance.
T~I; appliance IS manufactured with
~8 te neutral power supply wire and a
from connected Qreen
QKUndlnQ
~113 twisted together
Where local codes permit connecting
the home grounding candurzlor to the
neutral (while) junction box wire:
Cable ,rom
powersupply
Figure1
I.
Connect together 3 wires' Qreen
ard white appllonce cable wires and
the white We P tunctlon box
2.
Connect the& black wires, then the
two red wirei See Figure 1
Where local codes DO NOT permit
connecting the frame grounding
conductor to the neutral (whtte)
junction box wire:
Figure 2
I,
Separaie the Qreen and white
op~l~ance cable wares
2.
Conned the while appliance cable
WIE to the neutral [whlte) wire I" function
bc<
3. Conned the two black wires, then the
two red wires See Figure 2
4. Connect the groundlng wire to a
QrOUnded wire I" the~unct~on bon or lo a
grounded copper cold water pipe
Figure 3
5. DO NOT ground to a gas supply
pipe. Do Not connect to elecirlcal
supply until appliance IS permanently
grounded See figure 3. Grounded
cold water pipe must have metal
contlnulty to electrical ground and not
be Interrupted by plastic. rubber or
oiher electrlcol insulating connectors
such as hoses. fitlngs. washers or
gaskets (Including water meter or
pump). Any electrIcal lnsulatlng
connector should be jumped as
shown with a length of NO. 4 copper
wire securely clamped to bare metal
at both ends
If connecting to a four wire electrical
system: DO NOT connect the frame
QrOUndlnQ conductor to the neutral
[white) junction box wire
Figure 4
1. Separate the green and white
appliance cable wires
2. Connect the white appliance cable
wire to the neutral (white) wire injunction
box
3.
Connect the two black wires. then
the two red wires See Figure 4.
4. Connect the Qreen appliance
cable wire to green grounding wire in
the runction box
Now start.. .
With wall oven in kitchen.
1.
Remove racks and other parts lrom
inslde oven.
2.
Remove shlpplng materloIs. tape
and protective film from wall oven DO
Not remove the foam shIppIng base
at this time
screH
3.
Remove screws on each side of the
inner panel of lower oven door. Insert a
nail or W' equivalent in the hole in each
of the hinges. Close door as far as
possMe. Llfl oven door off of hinges and
set aside
Remove and discard foam shipplng
piece Lift wall oven up to cabinet
cutout. using the oven openings as an
area to grip Thread cable through
openrng in cabinet
Panel B