Switching The Server On And Off - Fujitsu Primergy TX100 S2 Operating Manual

5.2

Switching the server on and off

V
CAUTION!
If nothing appears on the screen but flickering stripes after switching on
the server, switch the server off immediately (see chapter
"Troubleshooting and tips" on page
The master switch and the On/Off button do not disconnect the server
from the mains voltage. To completely disconnect it from the mains
voltage, remove the power plug from the socket.
Switching the server on
The power-on indicator (item 4 in figure
the server is connected to the mains.
– Starting up for the first time:
Ê Press the On/Off button (item 4 in figure
Ê Insert ServerView Suite DVD 1 in the DVD drive.
Ê Follow the on-screen instructions (see also section
server and installing the operating system with the ServerView
Installation Manager" on page 52
installing the operating system without the ServerView Installation
Manager" on page
– Operating System already installed:
Ê Press the On/Off button (item 4 in figure
The server is switched on, performs a hardware self-test and boots the
operating system.
I
In the case of configurations with a large memory size, the boot
process may be prolonged and the screen may remain dark for about
20 seconds.
TX100 S2
57).
4 on page
or section
53).
Operating Manual
Installation and operation
45) is off (standby mode) if
4 on page 45).
"Configuring the
"Configuring the server and
4 on page 45).
49