Table of Contents
Advertisement
1
BAGGER MOUNT - 2009 Models
1.
Install the bagger mount tube to the rear guard
with
/
-18 x 3¼ bolts and flange nuts from kit.
5
16
NOTE: Depending on model, rear guard hole may
need to be drilled out to
large.
2.
Install kit support straps on the outside of the
mount tube as shown in the illustration. Using
a
/
-18 x 1¼ bolt, attach the front side of the
5
16
strap to the fender support. Do not add flange
nut at this time. Place the reinforcement plate to
the outside of the fender support. Secure with
additional 1¼ bolt and fasten both bolts with
flange nuts. Repeat steps on opposite side.
NOTE: The front side of the kit support straps
should be on the inside of the mower frame.
3.
Tighten all hardware.
Drill rear guard hole
to
/
" if needed
5
16
Mount Tube
ASSEMBLY
/
" if kit hardware is too
5
16
Support Strap
8063-044
Reinforcement
Plate
BAGGER SUPPORT -2008 and Prior Models
Remove rear engine guard (if installed) by removing
the six bolts that attach the guard to the frame.
1.
Place hitch on the rear of the mower.
Engine
Guard
Bolts
Rear Engine
Guard
3.
Install two of the previously removed bolts through
rear of the hitch weldment.
4.
Secure the sides of the hitch to the frame with
/
-18 x ¾
bolts and washers from the new
5
16
hardware, (two per each side).
Previously
Removed
Hardware
Engine
Guard
Bolts
8063-045
8063-046
Hitch
9
Advertisement
Table of Contents
