Installation Steps - ATEN CS62T User Manual

Installation Steps

1. Make sure that the power to any device that you
connect to the installation has been turned off. You
must unplug the power cords of any computers that
have the Keyboard Power On function.
2. Make sure that all devices you will be installing are
properly grounded.
To set up the CS62T, refer to the installation diagram on the
following page (the numbers in the diagrams correspond to the
steps, below) and do the following:
1. Plug your USB keyboard, USB mouse, and monitor into their
respective ports on the CS62T.
Note: 1. The mouse port can be used for USB peripheral
sharing. To do so, plug the peripherals and your
mouse into a USB hub, then plug the hub into the
mouse port.
2. If your are using a wireless keyboard and mouse
combo, the receiver must plug into the CS62T's
keyboard port in order for the hotkeys to function.
2. Plug your microphone and speakers into their respective
jacks.
3. Plug the USB (purple first, then black), video, and audio
connectors of the attached KVM cables into their respective
ports on the computers you are installing.
Note: If there is only one USB port on the computer, you can
connect a USB hub to the computer, then plug the
Keyboard/Mouse cable (purple) and then the File
Transfer cable (black) into the USB hub.
After you are all cabled up, you can power on the computers and
peripherals. The CS62T's power on default is to link to the first
computer that is powered on.
- 10 -