Map Mode; Map Display - Skoda Columbus Operating Instructions Manual

MAP mode

Map display

Press the button .
MAP
- maps goes to full-screen display
■

Change the display type
■
- 2D display
■ -2D

- 3D display
■ -3D

- Plan view of 2D map display with coloured display of various
■ -Topograph.

terrains (Mountains, Valleys etc.)
Function key "Navigation" - the menu is dependent on the operating type of the
■
route guidance » page 27, Function key "Navigation"
- indicates which source medium is currently active
■ A
choose another radio station from the memory
■
- pressing briefly changes to the beginning of the current title, repeated
■

pressing changes to the beginning of the previous title.
- brief pressing changes over to the beginning of the next title.
■

- the play function is stopped in the current position and the symbol
■

changes to - after pressing

■ In the menu Systems Setup if the time display is activated
tem, at position the current time is displayed.
A
■ Extras
■ Destination view - shows the currently selected travel destination in the map
display in the main menu Navigation. Use the function key on the right under
the compass display to center the map again on the vehicle position.
■ - the menu is dependent on the operating type of the route guid-
Split-screen

ance » page 28, Function key "Split-screen"
- changes between day and night design.
■ Day/night
26
MAP mode
Fig. 11
Maps display with split-screen
for compass display
the play function continues in this position.

» page 9, Setup Sys-
- selects points of interest category, which is displayed on the
■ POI selection
map using symbols » page 9, Setup Map
- during route guidance, when driving and turning on roads
■ Lane guidance

with more than one lane, a small split-screen with lane guidance will be inser-
ted in the map display.
- it is possible to switch the display to energy saving mode –
■ Switch off display
the display goes black and the current information about the audio source is
shown in the bottom row. The display can be switched on again by touching
the screen or any key other than the setting-up button
Change the map scale and display
Pressing the function key with the display of the currently selected map scale at
the bottom right will show further function keys for changing the map detail and
the map scale. If not used, these function keys fade out again after a few sec-
onds.
- briefly switches the map display to the overview display (small scale). It re-

turns again to the last display (large scale) after a few seconds.
or - to zoom in or out of the map, i.e.changing the map scale. The map scale
+ -
can also be changed by moving the slider  along the scale.
- changes to the overview map with start and finish point during route guid-

ance.
- Autozoom during route guidance. If Autozoom is active, the map scale will

change automatically depending on the route driven (motorway trip: large map
scale - city: small map scale). The switched-on Autozoom is indicated in the scale
display by . Autozoom is switched off again by pressing the scale again, or it can
be turned off manually using the menu button
Moving the map section using the vehicle position or destination
Move displayed map section by pressing and holding a finger on the screen and
dragging it across the screen without lifting the finger.
Function keys and symbols during route guidance
- current vehicle position

- centres the map section using the vehicle position

- centres the map section using the destination

» Fig. 1 on page 3.
1
» Fig. 1 on page 3.
15
